Knowledge

Plastic forming of metal products

It is one of the simplest and oldest metal molding processes by hammering and extrusion under cold working or high temperature working conditions.

Casting classification

Sand casting: Low cost, small batch, can process complex shapes, but may require a lot of post-processing processes.

The technical difficulties of photovoltaic support

According to the requirements of the national standard, the average thickness of the galvanized layer should be greater than 50μm, and the minimum thickness is greater than 45μm.

Photovoltaic bracket material

At present, the solar photovoltaic bracket commonly used in China is divided from the material, mainly there are three kinds of concrete bracket, steel bracket and aluminum alloy bracket.

Photovoltaic support design scheme

One of the most important characteristics of the assembly components of any type of solar photovoltaic bracket design scheme is weather resistance.

The main parameters of solar photovoltaic bracket

Installation location: building roof or curtain wall and ground